1. Press [8] key . “SCAN” blinks on the display.
2. Hold or [6] controls down to activate scan.
3. To stop the SCAN function, push PTT [11], or [7] or [9].
The B.SCAN allows the radio to stop on the channels not in use. It monitors periodically, for 5 secs only, the
channels not in use (without carrier).
To activate B.SCAN:
1. Press [8] until “B.SCAN “ flashes on the display.
2. Hold down or [6] to start the scanning mode.
3. To stop the B.SCAN function, push PTT [11], or [7] or [9].
18 DW (Dual Watch).
This feature allows you to scan 2 channels of your choice. It is useful when you want to keep track of two other
people.
To enable it:
1. Turn on the radio.
2. Select by / [6] keys the first channel you want to monitor.
3. Press repeatedly F [8] button until ”DW” blinks on the display.
4. Select the second channel to be scanned by / [6] controls.
Now the radio begins scanning between these 2 channels until activity is heard on either channel. The scanning
restarts when the carrier disappears.
To stop Dual Watch, press PTT [11], or [7] or [9] keys.
19 Reset
In case your ALAN 441 does not work properly or you want to cancel all the user settings, it is necessary to hold
[8] button down for 2 seconds while switching the unit on.
With this procedure, all the settings made by the constructor are restored.
To Next Page
Loading...
