Alan HM06 Series - 8.1.b Temporarily stopping the scanning; 8.1.c Temporary exclusion of channels from the channel scan; 8.2 Quick selection of the main channel; 8.3 Talk Around

English
16
theradiowillstopincorrespondencewiththechannelselected
duringthe programming phase (the priority or default channel)
and automatically enable the transmission mode. Scanning is
automaticallyresumedassoonasyoureleasethePTTkey.
To end the channel scan, repeat the operations described above.
The green MON/SCAN LED switches off.
8.1.b Temporarily stopping the scanning
If the channel scan stops in correspondence with an interesting sig
-
nal, press the F key (or
) linked to the temporary stop feature.
The scanning feature stops in correspondence with the channel,
which is permanently displayed on the screen.
To resume the channel scan, perform the operations described
above.
8.1.c Temporary exclusion of channels from the channel scan
If the channel scan feature tends to frequently stop in correspond
-
ence with one or more channels that you are not interested in, you
can temporarily excludethem fromthescan listbypressing the
F
key (or
)linkedtotheexclusionfeature.
The channel is temporarily removed from the scan list and the scan
-
ning operation is continued on the remaining channels.
2 Thechannelsexcludedfromthescanwillremaininthisstatus
untiltheradioisswitchedoffandwillbereinsertedintothelist
whentheradioisswitchedonagain.
8.2 Quick selection of the main channel
If the radio link provider has linked one of the F keys (or ) to this
feature, you can press this key to quickly select the channel you use
morefrequentlyandcongureitasmainchannel.
8.3 Talk Around
If you are using a repeater and a fault occurs, you can use the Talk
Around feature to continue communicating with neighbouring sta
-
tions, thus bypassing the repeater (i.e. by communicating in isofre
-
quency through the repeater output). To enable this feature:
1) Select a semiduplex channel (the TalkAround feature can be
enabledonlyforsemi-duplexchannels).
2) Press the
F key (or key ) linked to this setting. The green TA
LED switches on to indicate that the Talk Around feature has
been enabled.
To disable the Talk Around feature, repeat the operations described
above. The green TA LED switches off.
I Always remember to disable the Talk Around feature after
talking, otherwise you will not be able to use the repeater
after it resumes operation.