DOOR
CONTROLLER
The ADC-ACC1-17 Door Controller provides local decision
making, event reporting, and database storage capabilities
for the Alarm.com Smarter Access Control platform.
Two reader interfaces provide control for one supervised
physical barrier or two unsupervised physical barriers.
For UL compliance, the Power Sourcing Equipment (PSE), such as
a PoE enabled network switch and/or PoE power injectors, must be
UL Listed under UL294B.
Reader port 1 can accommodate a Wiegand reader and
provides LED and buzzer control. This port can alternatively
utilize a two-wire RS-485 bus to connect up to eight
Alarm.com expansion modules. Reader port 2 can
accommodate a Wiegand reader and provides LED
and buzzer control.
Two Form-C contact relay outputs may be used to control
locking hardware. The relay contacts are rated at 2A @
provided may be used for monitoring door position switches
as unsupervised or supervised. The ADC-ACC1-17 requires
Power over Ethernet (PoE) or 12V DC for power.
The ADC-ACC1-17 may be mounted in a 3-gang switch box;
on the provided mounting plate, or in an enclosure. The
supplied mounting plate has mounting holes that match
the ADC-ACX1 mounting footprint.
The SRAM is backed up by a rechargeable battery when input
power is removed. This battery should retain the data for
a minimum of 3 days. If data in the SRAM is determined to
cardholder data must be re-downloaded.
The initial charge of the battery may take up to 48 hours
to be fully charged.
To Next Page
Loading...
Need help?
General