Alarm.Com ADC-T3000 Operating Instructions

Changing the mode and setpoint
1. Press the button.
2. Select MODE.
◦ The modes are HEAT, COOL, AUTO, EMER, and OFF.
◦ The thermostat will only show the modes that are available based on the system configuration.
◦ When in EMER mode, the thermostat will flash EMER when the display wakes up, and it will show HEAT at
the top of the screen. Changing the mode will leave EMER mode.
3. Select the desired mode.
4. Once in the desired mode, press the and buttons to adjust the desired setpoint.
◦ In AUTO mode when the system is idle, the screen will display AUTO. The thermostat will display HEATING
when calling for heat and COOLING when calling for cool.
Changing the fan mode
1. Press the button.
2. Select the FAN MODE option.
◦ The fan modes are AUTO, ON, and CIRCULATE. The thermostat will only show the fan modes if it has been
configured to control a fan.
◦ AUTO mode will automatically turn the fan on when your system is either heating or cooling.
◦ CIRCULATE will turn the fan on for 15 minutes every hour by default. The duration for CIRCULATE can be
configured from the online account.
To locally operate the ADC-T2000:
1. Press any button to wake the thermostat up.
Note: To configure the thermostat display to always be on, see Can the Alarm.com Smart Thermostat display stay
on permanently?.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Thermostats/Alarm.com_Smart_Thermostat_(ADC-…
Updated: Mon, 20 Apr 2020 19:39:44 GMT
2

Alarm.Com ADC-T3000 Specifications

General

Brand	Alarm.Com
Model	ADC-T3000
Category	Thermostat
Language	English