2. After waking, the display will show the current mode and room temperature.
3. Press or once to display the current setpoint.
◦ The mode icon HEAT or COOL will begin to pulse.
4. Press or again to adjust to the desired set point.
5. Press at any time to change the mode.
◦ The modes are HEAT, COOL, AUTO, EMER, and OFF.
◦ EMER mode is available for Heat Pump systems. Press and hold while in Heat Mode to enter EMER.
◦ When in EMER mode, the display will read EMER when the thermostat wakes up and the HEAT icon will be
displayed. Changing the mode will leave EMER mode.
• In AUTO, the brighter icon will indicate which setpoint is currently displayed and active HEAT or COOL.
• After 5 seconds the display will return to the current room temperature. The mode icon will become solid to indicate
this. If powered by the “C” wire, the thermostat display will remain lit. If the thermostat is running on battery power
only, the display will turn off after 5 seconds to conserve energy. The thermostat will continue to operate while the
display is off.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Thermostats/Alarm.com_Smart_Thermostat_(ADC-…
Updated: Mon, 20 Apr 2020 19:39:44 GMT
3
To Previous Page
Loading...
Need help?
General
