Albrecht DB 270 - Page 44

•
In Frequency mode, press MENU+ 8 , the screen displays
• Press MENU to enter, it shows "OFF", press UP / DOWN to turn OFF this function
or select 67.0Hz to 254.1Hz CTCSS code,
•
then press MENU to confirm,
•
press EXIT return to standby.
NOTE: This transceiver has 50 groups CTCSS, see appendix (1) CTCSS frequency sheet.
Setting Transmitting CTCSS (T-CTCSS) --- MENU 16
For certain repeater operations, it can be necessary to use a certain CTCSS tone always
during your transmissions.
• In standby, press MENU+ 1 6 , the screen displays
•
Press MENU to enter, it shows "OFF", press UP / DOWN to turn OFF this function
or select 67.0Hz to 254.1Hz CTCSS code,
• then press MENU to confirm,
• press EXIT return to standby.
NOTE:
This transceiver has 50 groups CTCSS, see appendix (1) CTCSS frequency sheet.
Setting Receiving DCS (R-DCS) --- MENU 17
• In Frequency mode, press MENU+ 1 7 , the screen displays
• Press MENU to enter, it shows "OFF",
•
press UP / DOWN to turn OFF this function or select D023N to D754I DCS code,
• then press MENU to confirm,
• press EXIT return to standby.
NOTE: This transceiver has 105 groups DCS, see appendix (2) DCS frequency sheet. In it
DXXXN (between D023N to D754N) means Positive code while DXXXI (between D023I and
D754I) means Negative code.
Setting Transmitting DCS (T-DCS) --- MENU 18
• In Standby mode, press MENU+ 1 8 , the screen displays
• Press MENU to enter, it shows "OFF",
• press UP / DOWN to turn OFF this function or select D023N to D754I DCS code,
• then press MENU to confirm,
•
press EXIT return to standby.
NOTE: This transceiver has 105 groups DCS, see appendix (2) DCS frequency sheet.
DXXXN (between D023N to D754N) means Positive code while DXXXI (between D023I and
D754I) means Negative code.
Setting Scan Mode (SC-REV) --- MENU 19
This transceiver has three scan modes:
TO: When receiving signals, it will go on scanning without any operation within 5 seconds.
CO: It will stop scanning when receiving signals, while go on scanning after signal
disappeared 3 seconds.
SE: When receiving signals it will stop scanning.
• In standby, press MENU+ 1 9 , the screen displays
• Press MENU to enter, it shows "TO",