Alcatel-Lucent 8088 - Install the ALE International Bluetooth Wireless Handset; Uninstall a Bluetooth Device (Unpairing)

8AL90333ENAAed01 40 /53
8.10 Install the ALE International Bluetooth® Wireless handset
 Settings
 Device Bluetooth®
 Add
 Scan
The set scans for available Bluetooth® devices.
 Your Bluetooth® device needs to be prepared for pairing. Take the handset off the hook
and switch it off, then press and hold both handset buttons at the same time. You will hear a 3-
note tone and the LED will flash green and orange.
 Searching for Bluetooth® equipment. Wait for the detected equipment type and address to be
displayed.
 Select the relevant equipment.
 Add
 Enter the device PIN code (The default PIN code is 0000).
 Ok
The 3-note tone indicates that the handset has been installed correctly (the LED flashes green
or orange depending on the battery charge level).
After pairing the Bluetooth® accessory, you must define the accessory type in the audio settings.
 Settings
 Device Audio Accessory type BT Ok
 Bluetooth® accessory Headset Ok
Error messages
 The handset displays an error message indicating that the pairing is unsuccessful Check the
status of your Bluetooth® handset or the PIN code.
8.11 Uninstall a Bluetooth® device (unpairing)
 Settings
 Device Bluetooth®
 Select the Bluetooth® device to unpair.
 Delete
The Bluetooth® device is uninstalled (unpaired).