8AL90333ENAAed01 53 /53
Regulatory Statements
EUROPE
This equipment is in compliance with the essential requirements of Radio Equipment Directive (RED)
2014/53/EU and with Directive 2011/65/UE (ROHS).
The Declaration of Conformity may be obtained from:
ALE International 32 avenue Kléber – 92700 Colombes, France
ebg_global_supportcenter@al-enterprise.com
USA and Canada
This device complies with Part 15 of the FCC Rules and with RSS210 of Industry Canada. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired
operation. This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules and ICES003 of Canada. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try correcting the interference by consulting the dealer.
Exposure to Radio Frequency Signals.
This device has been designed and manufactured not to exceed the SAR (Specific Absorption Rate)
radio frequency power transmission limits established by the different countries concerned. The SAR
value for the Bluetooth® handset is 0.09 W/kg (the globally accepted maximum limit being 1.6 W/kg).
User Instructions
Only use the handset in temperatures between 5°C to +45°C (23°F to 113°F).
This apparatus is Hearing Aid Compatible (HAC).
Acoustic shock protection
The acoustic level of the signal generated by the handset earpiece is less than 130 dBspl for a transient
signal (123 dBspl for Australia) and less than 118 dBspl (rms) for a continuous signal (120 dBA for
Australia).
Directive 2003/10/EC specifying the risks inherent in noise at work
The ring contributes towards overall daily noise.
This device can be used for indoor operation in all the countries.
Privacy
Privacy of communications may not be ensured when using the Bluetooth® handset or any additionnal
Bluetooth® device.
Disposal
The equipment must be returned to a collection point for electronic equipment waste disposal.
Defective batteries must be returned to a collection point for chemical waste disposal.
The labels and icons presented in this document are not contractually binding and may be modified
without prior warning.
The information presented is subject to change without notice. ALE International assumes no
responsibility for inaccuracies contained herein. Copyright© ALE International 2016.
To Next Page
Loading...
