Alcatel-Lucent Halo H3P - Page 19

Copyright @ALE 2020 All Rights Reserved
19
VLAN is disabled on IP phones by default. You can configure VLAN for the Internet port and PC
port manually. Before configuring VLAN on the IP phone, you need to obtain the VLAN ID from
your network administrator.
The following table lists the parameters you can use to configure VLAN manually.
Parameter
LocalEnetcfgVlanEnable
config.<mac>.xml
Description
It enables or disables the VLAN for the Internet port.
Permitted
Values
true
false
Default
false
Web UI
Network -> IP Parameters -> LAN VLAN
Phone UI
Advanced Setting -> Network -> IP Config -> Vlan -> Vlan Config ->Use VLAN
Parameter
LocalEnetcfgVlan
config.<mac>.xml
Description
It configures the VLAN ID for the Internet port.
Note: It works only if “LocalEnetcfgVlanEnable” is phone to true.
Permitted
Values
Integer from 1 to 4095
Default
4095
Web UI
Network -> IP Parameters -> LAN VLAN Number
Phone UI
Advanced Setting -> Network -> IP Config -> Vlan -> Vlan Config ->ID
Parameter
LocalEnetcfgDataVlanEnable
config.<mac>.xml
Description
It enables or disables the VLAN for the PC port.
Permitted
Values
true
false
Default
false
Web UI
Network -> IP Parameters -> PC VLAN
Phone UI
Advanced Setting -> Network -> IP Config -> Vlan ->Data Vlan Config ->Use VLAN
Parameter
LocalEnetcfgDataVlan
config.<mac>.xml
Description
It configures the VLAN ID for the PC port.
Note: It works only if “LocalEnetcfgDataVlanEnable” is phone to true.
Permitted
Values
Integer from 1 to 4095
Default
4095
Web UI
Network -> IP Parameters -> PC VLAN Number
Phone UI
Advanced Setting -> Network -> IP Config -> Vlan -> Data Vlan Config ->ID
Halo series phones support VLAN discovery via DHCP. The predefined option 43-> option 58 is
used to supply the VLAN ID by default. And Option 58 has higher priority than option 132.