Alcatel-Lucent Halo H6 - Page 13

Copyright @ALE 2020 All Rights Reserved
13
If you configure the network Settings on the phone for an IPv6 network, you can phone up an IP
address for the phone by using SLAAC (ICMPv6), DHCPv6 or by manually entering an IP address.
Ensure that your network environment supports IPv6. Contact your ISP for more information.
When you enable both SLAAC and DHCPv6 on the phone, the server can specify the IP phone to
obtain the IPv6 address and other network Settings either from SLAAC or from DHCPv6, if the
SLAAC server is not working, the IP phone will try to obtain the IPv6 address and other network
Settings via DHCPv6.
The following table lists the parameters you can use to configure IPv6.
Parameter
LocalEnetcfgIpv6Mode
config.<mac>.xml
Description
It configures the Internet port type for IPv6.
Note: It works only if “LocalEnetcfgIpstack” is phone to IPv6.
Permitted
Values
Static
Dynamic
Default
Dynamic
Phone UI
Menu->Advanced (default password: 123456)Setting->Network->IP Config->IPv6
Settings-> IPv6 Mode
Parameter
LocalEnetcfgIpaddr6
config.<mac>.xml
Description
It configures the IPv6 address.
Example:
LocalEnetcfgIpaddr6= 2026:1234:1:1:215:65ff:fe1f:caa
Note: It works only if “LocalEnetcfgIpstack” is phone to IPv6, and "
LocalEnetcfgIpv6Mode " is phone to Static.
Permitted
Values
IPv6 Address
Default
Blank
Phone UI
Menu->Advanced (default password: 123456)Setting->Network->IP Config->IPv6
Settings-> IP
Parameter
LocalEnetcfgPrefixLen6
config.<mac>.xml
Description
It configures the IPv6 prefix.
Note: It works only if “LocalEnetcfgIpstack” is phone to IPv6, and "
LocalEnetcfgIpv6Mode " is phone to Static.
Permitted
Values
Integer from 0 to 128
Default
64
Phone UI
Menu->Advanced (default password: 123456)Setting->Network->IP Config ->IPv6
Settings-> Prefix6
Parameter
LocalEnetcfgRouter6
config.<mac>.xml
Description
It configures the IPv6 default gateway.
Example:
LocalEnetcfgRouter6= 3036:1:1:c3c7:c11c:5447:23a6:255