Copyright @ALE 2020 All Rights Reserved
Setting->Time&Date->SNTP Secondary Address
DmEnetcfgSntpRefreshPeriod
It configures the interval (in seconds) at which the phone updates time and date from the
NTP server.
Setting->Time&Date->SNTP Refresh Period
You can phone DST for the desired area as required. By default, the DST is phone to disable, if
phone to Automatic, it can be adjusted automatically from the current time zone configuration. The
time zone and corresponding DST pre-configurations exist in the AutoDST file. If the DST is phone
to Automatic, the IP phone obtains the DST configuration from the AutoDST file.
Topic
DST Configuration
The following table lists the parameters you can use to configure DST.
It configures Daylight Saving Time (DST) feature.
0-Disabled
1-Enabled
2-Automatic
Setting->Time&Date->DST Enable
DmlAdmcfgTimeZoneLocation
It configures the Daylight Saving Time (DST) Location.
Note: It works only if “LocalAdmcfgDstEnable” is phone to 2 (Automatic).
Setting->Time&Date->Location
It configures the Daylight Saving Time (DST) Type
Note: It works only if “LocalAdmcfgDstEnable” is phone to 1 (Enable).
Setting->Time&Date->DST Type
It configures the Daylight Saving Time (DST) StartDate
Note: It works only if “LocalAdmcfgDstEnable” is phone to 1 (Enable).and
LocalAdmcfgDstType is phone to date
To Next Page
Loading...
