Alcatel-Lucent OmniAccess 5740 - Page 11

Connecting to the OmniAccess 5740 USG Console Port
Left running head:
Chapter name (automatic)
6
Beta Beta
OmniAccess 5740 Unified Services Gateway Getting Started Guide
Alcatel-Lucent
To connect the OmniAccess 5740 USG to the console, perform the following
steps:
Step 1: Connect the RJ-45 end of the console cable to the front panel console
port on the OmniAccess 5740 USG and the DB-9 end to the serial port (COM) on
your computer/terminal.
Step 2: Start your terminal emulation software.
Example: kermit or hyperterm terminal (if you are using Microsoft Windows
operating system) or minicom terminal (if you are using Unix/Linux operating
system).
Step 3: Set the console session as follows:
Table 1: Console Properties
Step 4: Watch for console message output or press the Enter key to get the
device prompt.
Parameter Value
Baud rate 9600
Parity None
Data Bits 8
Stop Bit 1
Flow control None