Starting the OmniAccess 5740 USG
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
7
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway Getting Started Guide
STARTING THE OMNIACCESS 5740 USG
After installing your OmniAccess 5740 USG and connecting cables, follow the
procedure given below to start the system:
Step 1: Before you power ON the OmniAccess 5740 USG, check the following:
• Ensure that the power supply tray is securely inserted into the chassis.
• Ensure that the utility power cable is connected to a valid power cord in the rear
panel, and power is available from this source.
• Ensure that Services Engine is correctly and securely installed.
• Ensure that a PC or VT100 terminal is connected to the console port, using the
appropriate console cable. (If the system is not connected to a console, see the
“Connecting to the OmniAccess 5740 USG Console Port” section of this
document to connect the system to a console.)
Step 2: Power ON the OmniAccess 5740 USG.
Power on the OmniAccess 5740 USG by turning on the external power switch
located on the rear panel. If power supply is available, you should hear the
rotation of system fans, and the system LEDs showing activity. At this point, the
system begins its bootup sequence.
Step 3: Monitor the system front panel LEDs and console for various bootup
messages.
Once the system begins to startup, monitor the front panel LEDs for various
stages of booting process (refer to the table given below). In addition to the LEDs,
monitor the system console for various bootup text messages (an example of a
bootup message is given below). While a console access is not always required
for system startup, it is a good idea to monitor the console at least the first time
the system is booted and initial configurations completed.
To Next Page
Loading...
Need help?
General
