Alcatel-Lucent OmniAccess 5740 - Page 13

Starting the OmniAccess 5740 USG
Left running head:
Chapter name (automatic)
8
Beta Beta
OmniAccess 5740 Unified Services Gateway Getting Started Guide
Alcatel-Lucent
LED Information
The following table shows the state in which the main LEDs should be after a
startup:
Table 2: OmniAccess 5740 USG LED Status
The following is an example of a bootup message on OmniAccess 5740 USG:
OmniAccess 5740 USG Bootup Message
Example:
== Press ^C for Boot options ==
== Initiating startup sequence ==
Mounting internal storage medium...OK.
Checking storage medium...Done
###################################################
Alcatel-Lucent Software, Version 3.0.0, Build 82
Copyright (c) 2003-2010 by Alcatel-Lucent Inc.
Built on Tue Jul 6 13:41:35 IST 2010
###################################################
Services Engine [3] Starting internal services
Services Engine [3] Starting daughter processor
Services Engine [3] Installing image package
Services Engine [3] (SE) Installing image package
Services Engine [3] Initialization complete
Services Engine [3] (SE) Initialization complete
Loading Startup Config ...
No Startup Config
Loading Factory Default Config ...
/-------- Percent Complete --------
Username :
Step 4: Configure the system.
LED Status Description
SE LEDs
Active Off Power up status. This is the default
display when the system is first
powered on and before the software is
loaded.
Green SE card is active.
Yellow Indicates transient conditions (e.g.,
booting).