Alcatel-Lucent OmniAccess 5740 - Center Panel

Left running head:
Chapter name (automatic)
14
Beta Beta
OmniAccess 5740 Unified Services Gateway Getting Started Guide
Alcatel-Lucent
!
oam
top
!
!
!
!NHRP configurations!
top
!
!
! DHCP Relay configuration
!
!
end
Step 4: You can save the factory default configuration to the startup configuration
by using the following command:
Example:
ALU(config)# write mem
Note: In case of reload, the system always boots up with the factory default configuration
unless you explicitly save the modified configuration.
For further configuration of your OmniAccess 5740 USG, refer to the
“OmniAccess 5740 Unified Services Gateway CLI Configuration Guide”
available for download. Refer to the Product Documentation Card for instructions.