Type Message Location Additional Information Action
71 PRINTER THRESHOLD O.K.
Message emitted by the spooler
when the array where the tick-
ets are stored is less than 70%
full again
80 R_DHCP_SERVER_EXITED
DHCP server exited due to bad
configuration or option definition
error or IP address not in sub-
net or restart failed
Board loca-
tion
INFO 0 = Bad configuration
INFO 1 = Option definition error
INFO 2 = IP address not in subnet
INFO 3 = Restart failed
81 R_DHCP_SERVER_STATUS
DHCP server status changed
Board loca-
tion
INFO 0 = DHCP server normal exit
INFO 1 = DHCP server started suc-
cessfully
82 R_PASSWORD_AUTHENTICA
TION_LOCKED
83 R_PASSWORD_AUTHENTICA
TION_UNLOCKED
90 ENTERING AN MMC SESSION CPU (80) INFO 0 =1: ADMINISTRATOR
password; 2: INSTALLER pass-
word; 3: OPERATOR password; 5:
GUARDED password
91 END OF MMC SESSION CPU (80)
92 R_LOCAL_MGT_PWD_RESET comp_info[0]: update type:
- 01 The installer password has
been reset to default value
- 02 The installer password has
been restored to its previous
unknown value after expiration
of the limited delay
comp_info[1]: time frame duration in
minutes
100 BOARD BACK IN SERVICE
(Following a system stoppage
or after being unplugged)
Board loca-
tion
INFO 0 = type of board
101 BOARD UNPLUGGED Board loca-
tion
INFO 0 = type of board (if known)
INFO 1 = cause of rejection
104 TEMPORARY BOARD RESET Board loca-
tion
INFO 0 =1: hardware fault; 2: no re-
sponse from board; 3: fan fault; 4:
running on battery; 5: license prob-
lem; 6: maintenance problem; 7:
reason unknown
INFO 1 = cause of reset
% *
! "#$ ! % $& !
33/62
To Next Page
Loading...
