OmniSwitch 6800 Series Chassis and Hardware Components OmniSwitch 6800-24L
OmniSwitch 6800 Series Hardware Users Guide June 2007 page 2-9
OmniSwitch 6800-24L
The OmniSwitch 6800-24L is a stackable edge/workgroup switch offering 24 10/100Base-T ports, as well
as four combo SFP connectors for high speed connections.
The front panel of the OS6800-24L chassis contains the following major components:
• System status and slot indicator LEDs
• (20) 10/100Base-T ports
• (4) Combo 10/100/1000Base-T ports
• (4) Combo SFP connectors for 1000Base-X connections
• Console port (RJ-45)
Note. The 20 (non combo ports) 10/100Base-T ports on the OmniSwitch 6800-24L can be upgraded to
10/100/1000Base-T ports. Please contact your Alcatel-Lucent representative for more information.
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-13. For information on the chassis rear panel, refer to page 2-15.
OmniSwitch 6800-24L Front Panel
OmniSwitch 6800-24L
OK
PWR
FAN TMP
BPS
PRI
22
24
21
23
21 23
22 24
Console
15
16
17
18
19
20
21
22
23 LINK/ACT
24 LINK/ACT
13
14
3
4Speed 2
5
6
7
8
9
10
11
12
Speed 1
10/100Mbps and 10/100/100Mbps Ports
The OS6800-24L provides 20 fixed non combo
10/100BaseT (1–20) ports and 4 fixed 10/100/1000BaseT
combo ports (21–24). These ports are auto-sensing and
auto-MDIX and use RJ-45 connectors.
Console Port
The OS6800-24L front panel provides one
RJ-45 port for console connections. Con-
sole connections are used by network
administrators for switch management.
This female RJ-45 connector provides a
DTE console connection.
System Status LEDs
For detailed information on OS6800-
24L system status and other LEDs, refer
to page 2-13.
Combo SFP Connectors
The OS6800-24L provides four combo SFP connectors for 1000Base-X
high-speed connections.
By default, when an SFP is installed in a combo port, it takes over the port
number of the corresponding RJ-45 Ethernet port. In other words, if an SFP
is installed in the slot labeled 24, Ethernet port 24 is no longer available and
cannot be used for 10/100/1000 traffic. This default setting is referred to as
“preferred fiber.” Refer to “Configuring Ethernet Ports” in the Network
Configuration Guide for detailed information, including steps for configur-
ing combo port settings.
To Next Page
Loading...
