Viewing Primary and Backup Power Supply Status OmniSwitch 6800 Series Chassis and Hardware Components
page 2-54 OmniSwitch 6800 Series Hardware Users Guide June 2007
No Slot Number is Specified
If you do not enter a slot number, power supply information for all switches in the stack displays. For
example:
-> show power
Power Supplies in chassis 1
PS Operational Status
---------+-------------------
PS-1 48V UP
PS-2 48V UP
Power Supplies in chassis 2
PS Operational Status
---------+-------------------
PS-1 48V UP
PS-2 48V NOT PRESENT
Power Supplies in chassis 3
PS Operational Status
---------+-------------------
PS-1 48V UP
PS-2 48V UP
The example above shows the power supply status for a stack consisting of three switches. A backup
power supply is present and running in switches operating in slots 1 and 3; no backup power supply is
installed in the switch operating in slot 2—or the unit is powered off.
More Information on Stacked Configurations. For detailed information on stacked OmniSwitch 6800
Series switches, refer to “Managing OmniSwitch 6800 Series Stacks” on page 3-1.
To Next Page
Loading...
