Alcatel 1054D - Power on Your Phone; Power off Your Phone

12
For dual SIM models, SIM1 supports mini SIM card and micro-SIM for SIM2.
(1)
As to Single
SIM model
(2)
, which only supports mini SIM card. Do not attempt to insert other SIM types
like micro and nano cards, otherwise this may cause damage to your phone.
Charging the battery
Connect battery charger to your phone and plug into the socket.
• Charging may take about 20 minutes to start if the battery is out of power.
• Be careful not to force the plug into the socket.
• Make sure the battery is correctly inserted before connecting the charger.
• The mains socket must be near to the phone and easily accessible (avoid electric extension cables).
• You are advised to charge the battery to its maximum when using the phone for the first time
(approximately 3 hours) ( ).
• To reduce power consumption and energy waste, when battery is fully charged, disconnect your
charger from the plug; reduce the backlight time, etc.
The charge is complete when the animation stops.
1.2 Power on your phone
Hold down the key until the telephone powers on, type in your PIN code if necessary and then
confirm. The main screen will be displayed.
•If you do not know your PIN code or if you have forgotten it, contact your network operator.
Do not leave your PIN code with your telephone. Store this information in a safe place
when not in use.
If cell broadcast messages are displayed, you can browse through them or press to return to
the main screen.
While the phone is searching for a network, "Searching network/Emergency call" will be displayed.
1.3 Power off your phone
Hold down the key from the main screen.
(1)
1054D only.
(2)
1054X