INSTRUCTION MANUAL 4
DISCONNECTING THE HANDSET
If you wish to disconnect the Handset for any reason, follow these instructions.
1. To disconnect the Handset pull the sleeve - without turning.
WARNING! Do not pull on the Handset cord.
The connectors can only be disengaged by
pulling on the sleeve.
WARNING! The Handset should never be removed while the motor is running. The
following steps must be taken if the Handset is removed while the motor is running.
1. The Interface Module will beep twice every 15 seconds to
remind the driver that the Handset is disconnected while the
motor is running.
The main cable will also ash green.
2. To connect the Handset, line up the green arrow of the sleeve
to the main cable green line. You should hear a click!
Once the Handset has been reconnected, it
will display Wait…, followed by the appropriate
message based on the current vehicle state. The
message could read Drive Safely or RETEST.
To Next Page
Loading...
