15
GB
Installation instructions Alde AquaClear
Intelligent water disinfection
Alde AquaClear UV-C is a robust and compact water disinfection product for increased safety of
water quality in low pressure applications where water is replenished externally and stored in a tank,
and where the risk of microbiological growth is thus higher.
The disinfection is based on UVC light, through the latest UVC LED technology, and the product
neutralizes about 99% of microorganisms at water ows (up to 4 litres/min).
The pressure drop through the Alde AquaClear can reach 0.9 bar. Alde recommends using a fresh
water pump with a pressure of at least 2 bar.
Ordinary handling of an electrical product. The product works in plus degrees and up to about 50 °C
air temperature, about 40 °C water temperature. The product is intended for a water pressure of 2
bar and can withstand peaks up to 5 bar.
UV-C is dangerous for eyes and skin. Never look into a powered unit.
Units containing water must not be exposed to temperatures below freezing. If there is a risk of frost,
drain the unit. There is a glass pane in front of the product’s UVC source, and the glass is at risk of
breaking if water in the unit freezes.
The Alde AquaClear UV-C unit signal cable may only be connected to the Alde Compact
3030/3030 Plus or to the Alde LED panel. Electrical and signal connection to Alde Compact
3010/3020 can damage the unit.
Before cleaning the water system, remove the Alde Water Carbon lter to prevent the cleaning
particles from getting stuck in the lter.
The rst time you ush the tap after replacing the Alde Water Carbon lter, black carbon dust may
be present in the rst litre.
To Next Page
Loading...
Need help?
General