ALDI 15113902 - Performing a Wet Shave

AFTER SALES SUPPORT
www.aquarius-service.com
GB
IRE
00800 36463600
Handling
GBIRE
19
For a dry shave, follow the steps below:
1. Take the protective cap
1
off of the shaver
(seefig.A).
2. Use the electronic On/Off switch
5
to switch the
shaver on.
3. Use your free hand to stretch the part of your face
you intend to shave.
4. While applying gentle pressure, move the shaver
head
9
perpendicular to the direction of hair
growth.
5. After a few strokes, use your free hand to check the
results and repeat step 4 if necessary.
6. Shave as described in steps 2 – 4.
7. If necessary, use the trimmer
19
as described in the
chapter “Using the trimmer” (see fig. D).
8. After shaving, switch the shaver off by pushing the
electronic On/Off switch twice.
9. Clean the shaver as described in the chapter “Daily
cleaning after a dry shave”.
Wet shave
1. Slightly dampen your face and apply shaving cream
or gel to your face.
2. Take the protective cap
1
off of the shaver
(seefig.A).
3. Use the electronic On/Off switch
5
to turn the shav-
er on (see fig. A).