12. Thoroughly wash the shaver head under warm run-
ning water from the inside and outside (see fig.G).
13. Depress the large release button
8
to open the
shaver head
9
(see fig. A and E).
14. Thoroughly rinse off the shaver blades under warm
running water (see fig.H).
15. Use the electronic On/Off switch to switch the shaver
on with the shaver head opened for approx. 5 – 10
seconds in order to discharge any drops of water off
of the shaver blades.
16. Carefully dry the top part of the shaver head with a
lint-free cloth or a paper towel. In the process, do not
push the shaving foils in.
17. Use a lint-free cloth or a paper towel to thoroughly
dry off the shaver.
18. Use a lint-free cloth to dry the shaving foil unit
2
.
19. Close the shaver head and place the shaving foil unit
on the shaver so that the locking mechanism audibly
engages (see fig. F and L).
20. Oil the shaving foils as described in the chapter “User
maintenance for the shaving foils”.
21. Place the protective cap
1
on the shaver
(see fig. A).
The shaver is now ready for use again.
To Next Page
Loading...
