4. Push the small release buttons
4
to release the
shaving foil unit
2
.
5. Pull the shaving foil unit up and off (see fig. K).
6. Knock the shaving foil unit out gently over a sink to
remove stubble.
7. Place the shaving foil unit on a suitable base.
8. Depress the large release button
8
to open the
shaver head
9
(see fig. A and E).
9. With the shaver head open, use the electronic On/Off
switch
5
to switch the shaver on for approx. 5 – 10
seconds to dispel any stubble from the
shaver blades
3
(see fig. A).
10. Switch the shaver back off with the electronic
On/Off switch.
11. Close the shaver head and place the shaving foil unit
on the shaver head so that the locking mechanism
audibly engages (see fig. F and L).
12. Place the protective cap
1
on the shaver.
The shaver is now ready for use again.
Daily cleaning after a wet shave
1. Use the electronic On/Off switch
5
to switch the
shaver off (see fig. A).
2. Pull the 5 V plug
14
out of the shaver
(see fig. A and B).
3. Hold the shaver over the sink.
To Next Page
Loading...
