4. While applying gentle pressure, move the shaver
head
9
perpendicular to the direction of hair
growth.
5. After a few strokes, use your free hand to check the
results and repeat step 4 if necessary.
6. Shave as described in steps 2 – 4.
7. If necessary, use the trimmer
19
as described in the
chapter “Using the trimmer” (see fig. D).
8. After shaving, switch the shaver off by pushing the
electronic On/Off switch twice.
9. Clean the shaver as described in the chapter “Daily
cleaning after a wet shave”.
Using the 3-day beard trimmer function
You can use the protective cap of the shaver for
trimming. To do so, proceed as follows:
1. Use the electronic On/Off switch
5
to switch the
shaver off (see fig. A).
2. Place the protective cap
1
on the shaver head
9
.
3. Use the electronic On/Off switch
5
to turn the shav-
er on (see fig. A).
4. Run the shaver over the part of your face you would
like to shave.
To Next Page
Loading...
