15
USA
1 855 754 8297
Aldi-US@Supra-elektronik.com
feed slot
2
. If you do not insert the paper at the center, the paper
detection sensor does not detect the paper and the shredder
does not start. The same applies if you do not insert the CD/DVD
at the center of the CD/DVD/credit card feed slot
1
. The paper,
credit card or CD/DVD is drawn in automatically after activating
the respective detection sensor.
Collecting bins
Empty the respective collecting bins
3
/
9
regularly to avoid paper, credit
card, or CD/DVD residues being drawn into the cutter from underneath (see
Fig.B and C).
1. Switch off the paper shredder and disconnect the power plug before emp-
tying the respective collecting bins.
2. Remove the CD/DVD/credit card bin
9
first when emptying the pull-out
waste bin
3
.
3. Empty the collecting bins separately.
WARNING!
Risk of Injury!
Do not touch the cutting unit with your fingers.
Paper, CD⁄DVD or credit card jam
If you feed in paper at an angle or attempt to insert too much paper, the cutter
may block or work slowly, thus causing a paper jam.
1. Switch off the unit by setting the slide switch
7
to the OFF position.
2. Set the slide switch to the REV (reverse) position. The same applies if a CD/
DVD or a credit card gets stuck.
3. The paper, credit card, or CD/DVD is discharged through the respective feed
slot.
4. The paper jam is cleared or the CD/DVD/credit card feed slot
1
is free again.
5. Allow the unit to cool down to room temperature before you restart. If
necessary, insert paper in slightly less quantities.
To Next Page
Loading...
Need help?
General
