First use
15
3
2
4
3
5. If necessary, twist the quick-action drill chuck slightly into the SDS-Plus shank
holder if it does not immediately click into place.
6. Before you start working, make sure that the quick-action drill chuck has securely
locked into place in the SDS-Plus shank holder by trying to pull it out of the
SDS-Plus shank holder:
The securely engaged quick-action drill chuck can be moved slightly, but it cannot
be completely extracted from the SDS-Plus shank holder.
7. Rotate the quick-action drill chuck anticlockwise until you can insert the desired
drill bit (not included in package contents).
8. Insert the drill bit into the quick-action drill chuck up to the stop point.
9. Rotate the quick-action drill chuck clockwise until the drill bit is clamped firmly in place.
10. After the work: Make sure that the product has stopped moving, and lock the On/Off
switch by pushing the switch (right-hand/left-hand rotation) to the middle position.
11. Remove the rechargeable battery from the product.
12. Rotate the quick-action drill chuck anticlockwise until you can pull out the drill bit
from the quick-action drill chuck.
13. Pull the locking mechanism of the SDS-Plus shank holder on the product as far
back as possible in order to pull out the quick-action drill chuck from the SDS-Plus
shank holder.
Using the screwdriver bits
1. Make sure that the product is not moving, and lock the On/Off switch
6
by pushing
the switch (right-hand/left-hand rotation)
5
to the middle position (see Fig.1).
2. Pull the locking mechanism of the SDS-Plus shank holder
4
on the product as far
back as possible and hold it in this position (see Fig.3).
3. Insert the shank of the quick-action drill chuck
2
into the SDS-Plus shank holder
on the product and release the locking mechanism so that the quick-action drill
chuck clicks into the shank holder (see Fig. 3).
4. Before you start working, make sure that the quick-action drill chuck has securely
locked in place in the SDS-Plus shank holder by trying to pull it out of the SDS-Plus
shank holder:
The securely engaged quick-action drill chuck can be moved slightly, but it cannot
be completely extracted from the SDS-Plus shank holder.
To Next Page
Loading...
