First use
19
7. Let go of the On/Off switch to switch the product off.
8. If you stop working or put the product down:
Make sure that the product has stopped moving, and lock the On/Off switch by
pushing the switch (right-hand/left-hand rotation)
5
to the middle position in
order to prevent it from accidentally switching on.
9. An operating temperature between 4 °C and 40 °C is recommended.
Setting the mode and direction of rotation
− Use the changeover switch
9
to select the desired mode (see Fig.4).
4
9
• Drilling/Screwing: Press the button on the side of the changeover switch and
turn the ‘drill’ symbol to the marker.
• Hammer drilling: Press the button on the side of the changeover switch and
turn the ‘Hammer + Drill’ symbol to the marker.
Please note that only a little pressure needs to be applied when hammer drilling.
Applying too much pressure stresses the motor and could damage it.
− Use the switch (right-hand/left-hand rotation)
5
to select the desired direction
of rotation (see Fig.1).
• Right-hand rotation: Push the switch on the right side as far as it goes into
the product housing.
Use right-hand rotation (product rotates clockwise) for drilling, hammer drilling
and tightening screws.
• Left-hand rotation: Push the switch on the left side as far as it goes into the
product housing.
Use left-hand rotation (product rotates clockwise) to loosen screws or remove
jammed drill bits out of the hole.
To Next Page
Loading...
