Transport
22
NOTICE!
Risk of damage!
Improper cleaning may damage the product.
− Do not use any aggressive cleaners, brushes with metal or nylon bristles,
sharp or metallic cleaning utensils such as knives, hard scrapers and the
like. They could damage the surfaces.
Cleaning the product
− Clean the product after each use.
− Clean the outside of the product and the quick-action drill chuck regularly with a
dry or slightly moist cloth.
− Always keep the vent slots on the housing free of dust to prevent the product
from overheating.
− If necessary, use a soft cloth to rub down the product and accessories after cleaning.
Inspecting the product
Check the condition of the product regularly. Among other things, check to make sure:
− the switches
5
/
6
/
9
are not damaged (see Fig.A),
− the SDS-PLUS shank holder
3
and the quick-action drill chuck
2
are in perfect
condition,
− the vents are unobstructed and clean. If applicable, use a soft brush to clean them.
If you identify any damage, you must have it repaired by a specialist workshop
to prevent risks.
There are no parts that the user needs to service or lubricate inside the product.
Transport
− Always hold the product by the grip areas when carrying it.
− Switch off the product and remove the rechargeable battery (not included in the
package contents) when transporting the product.
− Protect the product and accessories from severe impacts and vibrations.
− Secure the product from falling down, falling over and sliding on inclined surfaces.
To Next Page
Loading...
