Troubleshooting
22
Troubleshooting
Problem Possible causes Solution
The product
doesn’t run or
switches off dur-
ing work.
The battery
8
is flat.
Use a charged battery.
The product is defective. Contact the manufacturer at the
service address specified on the
warranty card.
Poor performance
or uneven blade
movement.
The cutting blades of the
cutter bar
1
are partially
blocked by plant parts or
other foreign bodies.
Switch the product off, wait
until the cutting blades have
stopped and remove the bat-
tery. Remove any debris. Wear
protective gloves for this.
Poor cutting
performance
The cutting blades are blunt. Arrange for the cutting blades
to be replaced by a profession-
al. Make sure that suitable origi-
nal parts are used.
The cutting blades
become hot.
The cutting blades are not
sufficiently lubricated.
Lubricate the cutting blades as
described in the chapter “Main-
tenance and care”.
Maintenance and care
WARNING!
Risk of injury!
Accidentally starting the product may result in severe injury from the cutting
blades.
− Remove the battery from the product before starting cleaning or other
work.
WARNING!
Risk of injury!
Improper handling may result in severe injury.
− Let the product, especially the cutting blades, cool down before starting
cleaning or other work.
To Next Page
Loading...
