19
AUS
Attachment and operating
• Wear safety gloves.
• Avoid contact with skin and eyes.
• Make sure you observe the “Safety Instructions” paragraph.
• Only ever refuel the tool outdoors or in sufficiently ventilated rooms.
• Clean around the filling area. Contaminants in the tank will cause operating prob-
lems.
• Before refuelling, shake the container with the fuel mixture.
• Carefully pour in the fuel mixture to the lower edge of the filler.
• Close the fuel filler cap. Ensure the fuel filler cap closes tightly.
• Clean the fuel filler cap and the area around it.
• Check the tank and the fuel line for leaks.
• Before starting the motor, remove yourself from the fuelling place by at least three
metres.
Draining fuel.
Only ever empty the tank outdoors or in well-ventilated rooms. Make sure not to spill fuel
or chain oil into the soil (environmental protection). Use a proper base.
• Hold a collection container beneath the fuel drain bolt.
• Unscrew the tank cap and remove it.
• Allow the fuel to run out completely.
• Screw the tank cap on firmly by hand.
Check before use!
Check the safe condition of the device:
• Check the device for leaks.
• Check the device for visual defects.
• Check that all parts of the device have been securely fitted.
• Check that all safety devices are in proper condition.
Starting the blower vac
• To start the blower vac ensure that the intermediate suction/blower tube is fitted
correctly.
• To use the appliance follow the motor starting instructions as described in the op-
erating instructions.
• Make sure that nothing is covering the exhaust pipe as this would cause heat to
build up.
• Hold the handle firmly with your right hand and swing the nozzle back and forth so
that the desired area is cleared of contamination.
• The throttle control (3) and the engine switch (1) are integrated in the handle.
• With the throttle lockout (2), the engine can be locked at full throttle without con-
stantly pressing the throttle control (3). Caution: Before switching off the device,
push the throttle lockout (2) to idle.
To Next Page
Loading...