ALDI N1F-GT-250/18-D - Page 14

Assembly
-The cord, charger and baery pack can be le connected with the green LED indenitely. The
charger will keep the baery pack fresh and fully charged.
-The best storage place is one that is cool and dry away from direct sunlight and excess heat or
cold.
Note: The baery pack needs to be charged before rst use and whenever it is unable to per-
form jobs with sucient power that were easily done previously. Recharge discharged baeries
as soon as possible aer use or baery life may be greatly diminished.
For best results, baery pack should be charged in a locaon where the temperature is between
41°F and 104°F (5°C to 40°C). Charging me will increase if the baery is charged in lower or
higher temperature than specied.
The adapter, charger and baery pack maybe become warm when charging which is a normal
condion.
3. Assemble the guard (Fig. 3 & 4)
WARNING: Remove the baery pack before aempng to aach the guard. Never operate the
tool without guard rmly in place. The guard must always be on the tool to protect the user
-Push the head rotaon pedal to rotate the cung head to vercal posion, rotate the edge
guard forward to working posion.
-Turn the trimmer upside down so that you are looking down at the spool cap.
-Turn the guard upside down and put it on the motor housing.
-Insert and ghten the screw provided to complete the guard assembly..
Fig.2
AFTER SALE SUPPORT
support@sumec-na.com
11
1855 399 9415
MODEL: N1F-GT-250/18-D PRODUCT CODE: 45239 04/2015
A
C
B
Fig.3 Fig.4
Cordless Trimmer · 18V Lithium-ion Battery