ALDI N1F-GT-250/18-D - Replace String Spool

Operation
WARNING! Remove the baery pack before aempng to replace string spool.
-This trimmer uses 0.055 in. (1.4mm) diameter round nylon line. During use, the ps of
the lines will become frayed and worn, restarng the machine willl feed and trim a
fresh length of line.
-When no line is fed, remove the baery pack and turn the machine upside-down so
that you are looking down at the spool cap.
-Depress the tabs and remove the spool cap from the spool housing in the trimmer
head.
-Grasp empty spool retainer with one hand and pull it out.
-Unfasten the line end of new string spool and guide the line into the eyelet, push the
spool onto the head and rotate the spool slightly unl it’s fully inserted.
-Align the tabs on the spool cap with the slots in the housing.
-Push the cap onto the housing unl it snaps securely into place.
WARNING! To avoid tool damage; if the cung line protrudes beyond the line cut-o blade, cut
it o so that it just reaches the blade
.
4. Replace string spool (Fig 13 & 14)
AFTER SALE SUPPORT
support@sumec-na.com
15
1855 399 9415
MODEL: N1F-GT-250/18-D PRODUCT CODE: 45239 04/2015
Fig.15
Fig.16
Cordless Trimmer · 18V Lithium-ion Battery