laminator on the edge of the work surface.
− Avoid the build-up of heat by not placing the laminator direct-
ly up against a wall or under cupboards or similar.
− Protect the laminator from direct sunlight.
− Never place the laminator on or near hot surfaces (e.g. stove-
tops, heaters etc.).
− Ensure that the mains cord does not come into contact with
hot parts.
− Never expose the laminator to high temperatures
(heaters etc.) or to the effects of the weather (rain etc.).
− Never fill the laminator with liquid.
− Never attempt to clean the laminator by immersing it in water
and do not use a steam cleaner to clean it. Otherwise, you
could damage the laminator.
− Never laminate damp documents or organic objects (e.g.
flowers, leaves etc.).
− Do not cut the laminating pouches into pieces before laminat-
ing and do not in any case cut off the sealed edges from the
laminating sheets.
− Stop using the laminator if its plastic parts exhibit cracks or
breaks or are deformed. Only replace damaged parts with
corresponding original spare parts.
− Only laminate at room temperature (approx. 10–25°C).
− Never insert metallic objects (e.g. paper clips, staples etc.) or
objects other than laminating pouches which are intended for
this laminator into the laminating pouch infeed slot.
− The laminator has vents. Never cover them with other objects
such as magazines, blankets or similar.
To Next Page
Loading...
