Cleaning
WARNING!
Burn hazard!
The laminator will become hot during operation!
− Always let the laminator cool off completely before you clean it!
NOTICE!
Risk of short circuit!
Water that has penetrated the housing may cause a short circuit.
− Never submerge the laminator in water.
− Make sure that no water penetrates the housing.
NOTICE!
Risk due to improper operation!
Improper handling of the laminator may result in damage.
− Do not use any aggressive cleaners, brushes with metal or
nylon bristles, as well as sharp or metallic cleaning utensils such
as knives, hard scrapers and the like. They could damage the
surfaces.
1. Disconnect the mains plug before cleaning.
2. Let the laminator cool off completely.
3. Use a damp cloth to wipe off the laminator. Then let all parts dry completely.
Cleaning the heating rollers
1. Switch the laminator on.
2. Fold a sheet of paper and insert it, folded-edge first, into the pouch infeed slot
3
.
3. Keep repeating this process until no more glue deposits cling to the paper.
To Next Page
Loading...
