Operation
WARNING!
Risk of injury!
Improper handling of the laminator may result in injury.
− If an object (sleeves, tie etc.) is unintentionally taken into the
pouch infeed slot, immediately disconnect the mains plug.
NOTICE!
Risk of damage!
Improper handling of the laminator may result in damage.
− Originals with a treated surface, such as fax thermopaper or
Polaroid pictures, and papers with surfaces that may be altered
through heat should only be laminated using cold lamination.
− Only use one pouch per lamination, as pouches may stick
tightly together.
− Do not leave any laminating pouches in or next to the lamina-
tor after lamination.
When using the laminator, a slight odour may be produced. Ensure there
is sufficient ventilation in the room, e.g. by opening windows.
Hot lamination
1. Move the multi-function switch
7
to “II” (HOT) to switch the laminator on and
operate it in hot mode.
The READY indicator with thermo-transfer-technology
1
must be red.
2. Place the document that you wish to laminate between the two sides of the
laminating pouch
5
. Ensure that it lies flush with the closed edge.
3. Insert the laminating pouch closed-edge first into the pouch infeed slot
3
on the back of the laminator. The heating rollers will automatically pull the
laminating pouch in and move it to the pouch output slot
4
on the front of the
laminator. Don’t use force to pull out the laminating pouch.
To Next Page
Loading...
