8
After Sales Support
Telephone: 1300 886 649
• Set up the unit as described in the “Getting Started” section on page 6.
• Turn on the audio source (TV set, hi-fi system or any other audio device) that is
connected to the transmitter.
• Switch on the headphone set.
• Place the headphones on your head and adjust the volume to obtain the
desired sound level.
• If you cannot find the best reception frequency, press the “Auto Scan” button on
the headphones to get the fine scanned channel.
• You should now be able to move around freely from one room to another
without any interference. If interference does occur (interruptions in the signal),
press the “Auto Scan” button once to find a better reception channel.
NOTE: For better stereo reception, stay approximately seven metres away from
the transmitter when you press the “Auto Scan” button.
• If it is impossible to find a satisfactory frequency, change the channel setting
at the back of your transmitter, then press the “Auto Scan” button on the
headphones to find the corresponding channel.
NOTE: To both protect the transmitter and save power, the transmitter will
automatically switch off after approximately four minutes if there is no audio
signal, or if the signal received from the audio source is too weak for proper
reception. It will automatically switch back on if the signal returns to an
acceptable level.
Instructions
To Next Page
Loading...
General