Heart Rate Monitor Main functional modes
AFTER SALES SUPPORT service@produktservice.info / www.produktservice.info 1-800-493-9137
20
Stopwatch (in heart rate mode):
• Measurement range: 99 hours 59 minutes 59 seconds
• Resolution: 1/100 second
Countdown:
• Measurement range: 9 hours 59 minutes
• Resolution: 1 second
Heart rate:
• Measurement range: 30 to 240 bpm (beats/minute)
• Resolution: 1 bpm
Calories
• Measurement range: 0 to 99,999 kcal
• Resolution: 0.01 to 999.99 kcal
above 0.1 / 1
Fat
• Measurement range: 0 to 99,999 g
• Resolution: 0.01 to 999.99 g
above 0.1 / 1
Battery Change 5.9
Caution! Risk of explosion with improper replacement of the battery. Replacement
only with the same or equivalent type of battery.
For battery replacement, proceed as follows:
• Using a small, crosshead screwdriver, unscrew the four
screws on the cover at the back of the heart rate monitor
and remove them.
• Then, open the battery holder by carefully lifting the locking
bracket over the locking hook using the screwdriver.
• Remove the depleted battery and dispose of it properly
and environmentally.
• Insert a new 3V battery type CR2032 with the positive
terminal (+) upwards into the holder and push it until it locks in. Ensure that you
pay attention to the correct polarity.
• Place the back cover back onto the battery compartment. When doing so,
ensure that the rubber seal of the watch is not shifted or damaged. Screw the
cover back on with the four screws.
• Start the watch as described in point 5 “Main functional modes”.
• If irregular symbols should appear in the display, remove the battery again and
reinsert it. This will reset the microprocessor. After this, the heart rate monitor
should function normally again.
Note: Please note that after a battery replacement, all personal data needs to be re-
entered.
To Next Page
Loading...
Need help?
General
