Operation
32
5. Hold the probe tip with the infrared sensor
4
so that it can measure the temperature of the
liquid or surface within a distance of 0.39" (1cm).
6. Now push the button ( )
7
ear measurement.
A signal tone will indicate that the measure-
ment has started. A signal tone will sound twice
after approx. 2 seconds indicating that the
temperature measurement is complete. The
object temperature measured will appear on
the display.
If you would like to immediately switch
back to standby mode, you can push the
buttons (
) ear measurement and ( )
forehead measurement at the same
time. This will also be done automat-
ically after approx. 1 minute of button
inactivity.
To Next Page
Loading...