What to do if my ALDI Water Pump does not start?
If your ALDI Water Pump isn't starting or pumping water, first, make sure it's properly connected to the mains power supply. If that's not the issue, try manually raising the position of the float switch. You can also turn the pump off at the mains, inspect it, and clean any obstructions. In some cases, the motor might need to cool down, after which it will automatically restart.
Why is my ALDI Water Pump running but not pumping water?
If your ALDI Water Pump motor is running but not supplying water, try these steps: First, clean the priming vent. Next, turn off the pump at the mains and clear any foreign matter or debris from the base. You might also need to perform several start-ups to remove air or re-prime the pump. Check the discharge hose/tube for kinks, and replace it if necessary. Finally, turn off the pump and inspect the discharge outlet and filter for any obstructions.
How to increase the flow rate of my ALDI Water Pump?
If the flow rate of your ALDI Water Pump is reduced, start by priming the pump. Then, turn off the pump at the mains and clean the base to remove any foreign matter and debris. Remove any obstructions that you find. Reducing the discharge point height can also increase the flow rate. Finally, ensure the discharge lines are the correct length and that all assembly instructions have been followed.
What to do if ALDI Water Pump won't turn off?
If your ALDI Water Pump won't turn off even when the water level is low, the float switch might be stuck. Ensure that the float switch can move freely. You can also try tilting the float downward to the vertical position. If the pump continues to run, turn it OFF at the mains power supply.
General| Brand | ALDI |
|---|---|
| Model | WLBCF310 |
| Category | Water Pump |
| Language | English |
To Next Page
