Understanding and using these operating instructions 750W Submersible Water Pump
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com 1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290 (toll free)
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
750W Submersible Water Pump
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
13
Setting up the Submersible Pump for use
Before operating your Pump, undertake the following:
• Read all documentation and instructions carefully.
• Ensure the distance from the base (6) of the submersible Pump to the
max height of the water line does not exceed the maximum immersion
depth of 7m. (Pic G)
• Ensure the distance from the base of the Pump to the point of water
distribution does not exceed the maximum head height of 8m. (Pic G)
• Ensure the body of water the Pump is being submersed into is large
enough to allow the float to float and move freely. We recommend a
minimum area of 50cm for each side of the submersible Pump. (Pic G)
• Do not place the submersible Pump into directly onto mud or debris.
If the Pump is being used in dirty water it is recommended to place the
Pump on a clean hard surface in the water such as a concrete slab or
block. This will avoid the Pump becoming blocked.
• Note: The Pump must be used with a residual current device with a rated
residual current of 30mA or less.
• The Pump is not suitable for use with spa’s, swimming pools or similar
applications.
• Do not use the Pump in
applications in which
people or animals are
present in the water
during operation.
It is prohibited to operate
the equipment if a person
or animal is in the
danger area.
To Next Page
Loading...
Need help?
General
