ALDI WLBCF310 - Installing the L-Shape Elbow Connector & Adaptor

Understanding and using these operating instructions 750W Submersible Water Pump
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com 1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290 (toll free)
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
750W Submersible Water Pump
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
11
Installing the L-shape Elbow Connector and Adaptor
IMPORTANT: The elbow outlet connector supplied with the Pump is a
specific elbow designed for the Pump to provide an adequate seal through
an arc of 180°. Refer points 1 & 2 below in the section “Installing the L-shape
elbow connector”. It is recommended to only use this supplied L-shape
elbow connector on the outlet of the Pump.
1. Screw on the L-shape elbow connector (8) to the Pump outlet (7)
in a clockwise direction until the elbow is tight and FULLY SEATED. (Pic A)
2. To obtain the required outlet direction, the elbow can be rotated in an
anti clockwise direction up to, and NOT exceeding 180° from the fully
tight position. (Pic B)
3. Screw the adaptor (9) in a clockwise direction until tight, onto the other
end of the L-shape elbow connector (8). (Pic C)
180° leeway
A.
B.
C.