AUS
bgs700 <Chapter>
Text
29
AFTER SALES SUPPORT
1300 855 831
support@scheppach.com.au
MODEL: HBS20 PRODUCT CODE: 60339 04/2018
XIII. Storage
Store the device and its accessories in a dark, dry and frost-proof place that is in-
accessible to children. The optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust and moisture.
Store the operating manual with the electrical tool.
XIV. Electrical connection
The electrical motor installed is connected and ready for operation. The
connection complies with the applicable Australian standards.
The customer‘s mains connection as well as the extension cable used must
also comply with these regulations.
Important information
In the event of an overloading the motor will switch itself off. After a cool-down pe-
riod (time varies) the motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is often damaged.
This may have the following causes:
• Passage points, where connection cables are passed through windows or
doors.
• Kinks where the connection cable has been improperly fastened or routed.
• Places where the connection cables have been cut due to being driven over.
• Insulation damage due to being ripped out of the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not be used and are life-threat-
ening due to the insulation damage.Check the electrical connection cables for
damage regularly. Make sure that the power is switched off before inspecting the
cable. Electrical connection cables must comply with the applicable Australian
standards and must be correctly marked. Only use connection cables with the
marking ''H05VV-F''.Replacement cables can only be tted by an approved and
certied electritian. If you are in any doubt please contact the help line at the foot
of this page.
AC motor
• The mains voltage must be 230 - 240 V~
• Extension cables up to 25 m long must have a cross-section of 1.5 mm
2
.
Connections and repairs of electrical equipment may only be carried out by an
electrician.
AUS
HBS20 Storage/Electrical connection
To Next Page
Loading...
Need help?
General
