HMSOMP
Safety reg
-
Follow the instructions
for lubrication
and for tool replacement
-
Checkthe
connection cable of
the electrictool regularly
and have it re-
placed
by a recognised
specialist when damaged.
-
Check extension cables
regularly and
replace them when damaged.
-
Keep the handle dry,
clean and
free of oil and
grease.
15
Pull
the
plug
out of the outlet
-
Never remove
loose splinters,
chips
or
jammed
wood
pieces
from the run-
ning saw blade.
-
During
non-use of the electrictool
or
priorto
maintenance
and when replac-
ing
tools such as saw blades,
bits, milling heads.
-
When the
saw blade is blocked
due to abnormal feed force
during cutting,
turn the machine off
and disconnect it
from
power
supply.
Remove the work
piece
and
ensure that the saw
blade runs free. Turn
the machine on and
start new cutting operation
with reduced feed force
16 Do not leave a tool key
inserted
-
Before switching on, make
sure that keys and
adjusting tools
are removed.
17 Avoid inadvertent
starting
-
Make
sure thatthe switch
is switched off when
plugging
the
plug
into an
outlet.
l8 Use extension cables
for outdoors
-
Only use approved
and appropriately
identified extension
cables for use
outdoors.
-
Only use
cable
reels
in the unrolled
state
19 Remain attentive
-
Pay attention
to what
you
are
doing. Remain sensible when
working. Do
not
use the electric tool when
you
are distracted.
20 Check the electric tool
for
potential
damage
-
Protective
devices and other
parts
must be carefully inspected
to ensure
thatthey are fault-free
and function
as
intended
priorto
continued use of the
electric
tool
-
Check
whether the moving
parts
function faultlessly and do
not
jam
or
whether
parts
are
damaged. All
parts
must be
correctly mounted
and all
conditions must be
fulfilled to ensure fault-free
operation of
the electric tool.
-
The moving
protective
hood
may not be fixed in the open
position.
-
Damaged
protective
devices
and
parts
must be.properly
repaired
or
re-
placed
by a recognised
workshop, insofar
as nothing different
is specified in
the operating manual.
-
Damaged
switches must
be
replaced
at a customer
service workshop
-
Do
not use any faulty or
damaged connection
cables.
-
Do not
use any electric tool
on
which
the switch cannot
be switched on
and
off
21 ATTENTION!
-
Exercise
elevated caution
for double mitre
cuts.
AFTER
SALES
SUPPORT
,I5
t
o,:
1300
855 831
E support@scheppach.com.au
MoDEL:HM80MP PRODUCT
CODE: 53666
06/2017
To Next Page
Loading...
