@
lationsHMSOMP Safety regu
-
When transporting the electric tool, only use the transport devices. Never
use
the
protective
devices for handling or transport.
-
Make
sure thatthe
lower
part
of the
saw blade is covered during transport,
e.g. by the
protective
device
-
Be sure to only use spacers and spindle rings specified by the manufacturer
as suitable
for the intended
purpose.
-
The fioor around the machine must be level, clean and free of loose
parti-
cles, such as chips and cutting residues
-
Do
not remove
any cutting residues or other
parts
of workpieces from the
cutting zone while the
machine
is running and
the saw
unit
is not at rest.
-
Make sure that the machine is always secured on a workbench or a table if
at all
possible.
-
Support long workpieces
(e.9.
with a roller table) to
prevent
them sagging at
the end of a cut.
Warning! This electric tool
generates
an electromagnetic field during operation
This field can impair active or
passive
medical implants under certain conditions. ln
order to
prevent
the
risk of serious or deadly injuries, we recommend that
persons
with medical implants consult with their
physician
and the manufacturer of the
medi-
cal implant
prior
to operating the electric tool.
SAFETY INSTRUCTIONS
FOR THE HANDLING OF SAW BLADES
1 Only use insertion tools if
you
have mastered their use
2 Observe the maximum speed. The maximum speed specified on the insertion
tool may
not
be
exceeded. lf
specified,
observe the speed range.
3 Observe the motor
/
saw blade direction
of rotation.
4
Do not use any insertion tools with cracks Replace cracked insertion tools.
Repairs
are not
permitted.
5 Clean
grease,
oil and water off of the clamping surfaces.
6 Do not use any
loose reducing rings or bushes for the reducing of holes on
saw blades.
7
Make
sure that
fixed reducer rings for securing the insertion tool have the
same
diameter and have at least 1/3 of the cutting diameter.
8
Make
sure that
flxed reducer rings are
parallel
to each other
9 Handle insertion
tool with
caution They
are ideally stored in the original
pack-
age or special containers. Wear
protective gloves'in
orderto
improve
grip
and
to
further
reduce
the risk of injury.
10 Priorto the use of
insertion
tools, make
sure
that
all
protective
devices are
properly
fastened
11 Prior to use, make sure that the insertion tool
meets
the technical require-
ments of this electric tool and is
properly
fastened.
12
Only use
the
supplied saw blade for sawing operations in wood
AFTER
SALES
SUPPORT
E support@scheppach.com.au
MODEL:HM80MP PRODUCT CODE: 53666 06/2017
17
t -' 1300 855 831
To Next Page
Loading...
