@
nection
HMSOMP
Electrical
con
Xll. Electrical
connection
The electrical motor installed
is connected and
ready for operation.
The
connection complies with
the applicable Australian
standards.
The customer's
mains connection
as well as the extension
cable used must
also comply with these regulations.
lmportant
information
ln the event of an overloading
the motor will switch itself
off. After a cool-down
pe-
riod
(time
varies) the motor can
be switched back on again
Damaged electrical
connection cable
The insulation on electrical connection
cables is often
damaged.
This may have
the
following
causes:
o
Passage
points,
where connection cables
are
passed
through windows
or
doors.
o
Kinks where the connection
cable has been improperly
fastened
or routed.
r
Places where the connection
cables have been
cut due to being
driven over.
r
lnsulation
damage due to being ripped
out of the wall outlet.
o
Cracks due to the insulation ageing.
Such damaged electrical connection
cables must not
be used and are
life-threat-
ening due
to the insulation damage.Check the
electrical connection
cables for
damage
regularly. Make sure that
the
power
is switched
off before inspecting
the
cable Electrical connection cables
must comply with the
applicable Australian
standards and must be
correctly marked. Only use
connection cables
with the
marking
"HOSVV-F"
Replacement cables
can only be fitted
by an approved and
certified electritian lf
you
are in any
doubt
please
contactthe
help line
atthe foot
of this
page
AC motor
r
The mains voltage must be 230 -240V-
o
Extension
cables
up
to
25
m long must have
a cross-section
of 1.5 mm2.
Connections and repairs of
electrical equipment may
only be
carried out by
an
electrician.
Please
provide
the following information
in the event
of any enquiries:
.
Type of current for the motor
e
Machine
data
-
type
plate
o
Machine data -
type
plate
AFTER
SALES SUPPORT
!
r,!
1300 855 831
27
E support@scheppach.com.au
PRODUCT
CODE: 53666
06/2017
MODEL: HM80MP
To Next Page
Loading...
