and recyclin
g/Troubleshooting
HMSOMP
Xlll. Disposal and recycling
The equipment is supplied in
packaging
to
prevent
it from being damaged in tran-
sit. The raw materials in this
packaging
can be reused or recycled
The equipment
and its accessories are made of varioustypes
of
material,
such as metal and
plastic.
Defective components must
be
disposed of as special waste Ask
your
dealer or
your
local council.
XlV. Troubleshooting
28
AFTER
SALES
SUPPORT
E support@scheppach.com.au S
rus
IJQ$ 855 831
MODEL: HM80MP PRODUCT CODE: 53666 06/2017
Fault Possible cause Remedy
Motor does
not
work
Motor, cable
or
plug
de-
fective, fuses burnt
Arrange
for
inspection
of the machine by
a specialist. Never repair
the
motor
your-
sell
Danger!
Check fuses and replace as
necessary
The motor
starts up slowly
and does not
reach operating
soeed
Voltage too low, coils
damaged, capacitor burnt
Contact the utility
provider
to check
the
voltage. Arrange for inspection
of the
motor
by a specialist Arrange for replace-
ment of the capacitor
by
a specialist
Motor makes
excessrve
notse
Coils damaged, motor
defective
Arrange for inspection of the motor
by a
specialist
The motor does
not reach its
full
power.
Circuits in the network are
overloaded
(lamps,
other
motors, etc.)
Do not use any other equipment or mo-
tors on the same circuit
Motor over-
heats easily
Overloading of the motor,
insufficient cooling of the
motor
Avoid
overloading the motor while cutting,
remove dust from the motor in order to
ensure
optimal cooling
of the motor
Reduced
cutting
power
when sawing
Saw
blade
too small
(ground
too much)
Readjust
end stop ofthe saw unit
Saw cut is
rough orwavy
Saw blade dull, tooth
shape not appropriate for
the
material thickness
Resharpen saw blade and/or use
suitable
saw
blade
Workpiece
pulls
away and/
or splinters
Excessive cutting
pres-
sure and/or saw blade not
suitable for use
lnsert suitable saw blade
To Next Page
Loading...
