ALDI WZVC 1930 SA User Manual

AFTER SALES SUPPORT
0151 649 1500 1890 946244
www.einhell.co.uk
34
Use
Wet & Dry Vacuum Cleaner – WZVC 1930 SA
Use
Description of components and control elements
Proper use
This wet and dry vacuum cleaner is designed for wet and dry vacuuming using the
appropriate filter. The equipment is not suitable for the vacuuming of combustible, explosive
or harmful substances. Although this unit can be used to vacuum wet spillages, etc., this unit
cannot be used as a carpet cleaner (i.e. there is no function on the unit to spray a cleaning
solution onto the carpet and then vacuum it back off the carpet.) The operating instructions
as supplied by the manufacturer must be obeyed to ensure that the equipment is used
properly & the manufacturer cannot be held liable for damage or injury caused by improper
or incorrect usage.
The equipment is to be used only for its prescribed purpose. Any other use is deemed to be a
case of misuse. The user/operator and not the manufacturer will be liable for any damage or
injuries of any kind caused as a result of this.
Please note that our equipment has not been designed for use in commercial, trade or
industrial applications. Our warranty will be voided if the machine is used in commercial,
trade or industrial businesses or for equivalent purposes.
Operation
Please note that the statutory regulations governing noise abatement may differ from one
location to another.
Each time before use, check the following:
– That the equipment is in perfect condition and that the safety devices are complete.
– That all screws are securely fastened.
1. Connecting up the machine and switching it on (Fig. 1)
– Connect the 13A plug
28
on the vacuum cleaner power cable (Fig. 1) either to a 13A socket
on the mains supply or via a 13A, 3-core extension power cable to a 13A socket on the mains
supply.
2. The 3-position ON/OFF switch (See Fig. 14)
– The vacuum cleaner can be switched ON (switch position 'I') and OFF (switch position '0') by
using the ON/OFF switch
2
(Fig. 14 - item
2
).
– When the switched is set to the Automatic mode (switch position 'AUTO') and a power tool
is connected to the 13A socket
T
, then operating the power tool will switch the vacuum
cleaner ON/OFF. (Note that the vacuum cleaner will run for a few seconds after the tool is
switched off, to assist in removing residual dust etc., in the power tool and cleaner system).
72115_2342197_11016_UG.indd 34 16/05/2016 10:07 am

ALDI WZVC 1930 SA Specifications

General

Brand	ALDI
Model	WZVC 1930 SA
Category	Vacuum Cleaner
Language	English