5
crash
hi-hat
snare
ride
tom 3
tom
1
tom
2
hi-hat
control
kick
control
4. Remove the wing-nuts and
washers from each cymbal stand.
Attach the cymbal pads to the
poles.
Reattach the wing-nuts and
washers and tighten to secure the
cymbal to the pole.
5. Connect the multipin head of the
included cable snake to the port on
the bottom side of the E-Drum Total
module.
Tighten the two screws to secure
the cable snake to the module.
6. Connect the labeled 1/4" cables at
the tail end of the cable snake to
each respective drum pad, cymbal
and foot pedal in the drum kit.
Secure the cables using the Velcro
strap.
Feel free to adjust the tension of
each mesh head by evenly
tightening each tension rod with the
included drum key
The tighter the tension, the more
rebound and responsive the drum
head will have. Welcome to your real
drum experience!
To Next Page
Loading...
Need help?
General
