Description of Controls – Chapter 5
MidiVerb 4 Reference Manual 45
BYPASS LED Indicator
The [BYPASS] LED will be lit whenever Bypass mode is enabled. Bypass mode can
be toggled on and off by simultaneously pressing the [PROG] and [UTIL] buttons, or
by pressing a footswitch connected to the [FOOTSWITCH] jack (if the footswitch is
switched to act as a “Bypass” function; see “UTILity Button”, next page).
VALUE Knob
The [VALUE] knob is used to raise or lower the selected value in the display by
turning either clockwise or counterclockwise. If the [PROG] button is lit, turning the
[VALUE] knob lets you scroll through the internal Programs. When an effect
parameter is selected (flashing in the display), turning the [VALUE] knob will alter its
value.
PROGram Button
The [PROG] button is used to select Program mode. When Program mode is
selected, the [PROG] button will be lit. The [VALUE] knob may then be used to scroll
through programs. The [PROG] button is also used to toggle between the Preset and
User banks. The display will show either "PRESET" or "USER" indicating the
currently selected bank.
The [PROG] button is also used in conjunction with the [UTIL] button to toggle
between "BYPASS" ON and "BYPASS" OFF.
EDIT/PAGE Button
The [EDIT/PAGE] button is used in either Program or Utility mode to advance
through the available pages. When [EDIT/PAGE] is pressed in Program mode, the
Program’s parameters will be displayed for editing. When the [EDIT/PAGE] button is
pressed in the Utility mode it advances through the various pages of Utility
functions. The total number of pages will appear in the lower left corner of the
display, and the currently selected page will have a box around it. Each time
[EDIT/PAGE] is pressed it will advance to the next page; when the last page is
reached it cycles back to the first page.
A/B/C/D (NAME/ESC/</>) Buttons
The [A], [B], [C] and [D] buttons are used in Program mode to select the parameters
to be edited within each of the available page. When in Program mode, pressing any
of the [A], [B], [C] and [D] buttons will select the corresponding parameter (A, B, C,
or D) in the display, and the selected parameter will flash.
When selecting a parameter, if the corresponding [A], [B], [C] or [D] button is held for
longer than one second, a brief description of that parameter will appear in the
display. This is the MidiVerb 4’s built-in online help system. If there is no
corresponding parameter for one or more of the [A], [B], [C] and [D] buttons in a
particular page, it will be indicated in the display when the button is pushed. For
example, if you were editing an effect in page one which did not have an “A”
parameter displayed and the [A] button was pressed, the message “NO "A" PARAM
ON PAGE 1” would briefly appear.
The [A], [B], [C] and [D] buttons also serve another function. When in Store mode
([STORE] button flashing), the [A], [B], [C] and [D] buttons are used to change the
Program’s name. Pressing [A/NAME] moves the cursor in the display to the first
To Next Page